{"id":5856,"date":"2020-10-21T06:10:12","date_gmt":"2020-10-21T06:10:12","guid":{"rendered":"http:\/\/www.alalloycasting.com\/?p=5856"},"modified":"2020-10-26T03:41:17","modified_gmt":"2020-10-26T03:41:17","slug":"ceramic-filter-devices","status":"publish","type":"post","link":"https:\/\/www.alalloycasting.com\/ar\/ceramic-filter-devices\/","title":{"rendered":"Ceramic Filter Devices"},"content":{"rendered":"

Some factories use ceramic filter devices. The outer shell of the ceramic filter devices is welded with steel plates, lined with aluminum silicate fiber, and then built with a layer of light refractory bricks, and the inside is brushed with talcum powder. The inner cavity of the filter is divided into two compartments A and B by porous ceramic plates or silicon carbide plates. Room A is the filter room, the filter tube is assembled on the partition hole, and the assembly part is sealed with aluminum silicate fiber felt. Room B is a storage room for collecting filtered metal. There is a heating cover on the upper part of the filter with a resistance heating wire inside. The thermocouple continuously measures the temperature, and the electronic potential difference controls the metal temperature in the filter. There is a discharge eye at the bottom of the filter. There are two types of all working indenters. Install filter tubes in the filter room, and the number of installations depends on the needs. The melt enters the filter chamber A connected to it along the launder from the static furnace, then seeps out through the micropores of the filter tube, collects in the storage chamber, and finally enters the crystallizer through the flow plate.<\/p>\n

\"Ceramic<\/p>\n

Pay attention to the following issues when designing and using ceramic filters<\/a> according to product requirements:<\/p>\n