Alumina fiber flow box can control the flow of molten aluminum during foil casting. The boîtier de régulation de débit uses high silicon melting materials. It has the features of nonstick molten aluminum and erosion resistance, which can maintain the stability of the internal layer. AdTech boîte de circulation en fibre d'alumine is mainly used for high value-added micron foil and PS plate casting.
Dimensions
| Article | Taille | Flow Control Supporting | Customized |
| Standard | 200-600 | As Drawing | As Drawing |
Flow Control Box Parameter
| Article | Densité (g`cm3) |
Module de rupture (816 °C·MPa) |
Dilatation thermique (680 °C·K-1) |
Conductivité thermique (540 °C W/m·K) |
Max Working Température (°C) |
|
| Valeur typique | Roll-PH | 1.0-1.4 | 10.5-11.8 | 1.23*10-6 | 0.5-0.65 | 1260 |
Avantages
- The automatic flow controller can reduce manual cost and improve molten aluminum flow stability.
- The high silicon melting materials density at 1.0-1.4 g/cm3. AdTech flow control box has good insulation performance, a smooth surface. Good erosion resistance can save material costs.
Instructions for Alumina Fiber Flow Box
- Install and assemble according to the drawing, keep it intact and smooth.
- Heat the boîtier de régulation de débit 1 to 2 hours until the target temperature. Observe the lining surface if being red (below 800℃), which can remove crystal water.
- If electric heating not available, it is better to heat by flame. Control the flame temperature and avoid direct fire cause the lining cracked.